Primary product focus
Dry screw vacuum pumps
Review this route when an oil-free pumping path is part of the process requirement.
Then check the inlet condition, duty cycle, and site constraints.
Industrial vacuum pump technologies for process applications
Start with working pressure and required volumetric flow rate. They narrow the initial product review to the technologies that can suit the duty. We then check the gas or vapor condition, any oil or water contact, and the utilities available at the site before recommending a product path.
Product Technologies
Choose a vacuum pump technology
SC Air Power Tech supplies dry screw, water-injected screw, oil-injected screw, and liquid ring vacuum pumps for industrial process applications.
Product line
Water-injected screw vacuum pumps
Review this route when water condition and water handling belong in the system review.
Then check process compatibility, site utilities, and the water arrangement.
Product line
Oil-injected screw vacuum pumps
Review this route when oil contact and oil management are acceptable for the process.
Then check the gas condition, cleanliness requirements, and operating cycle.
Product line
Liquid ring vacuum pumps
Review this route when wet gas, condensable vapor, or sealing-liquid handling is part of the duty.
Then check the sealing-liquid arrangement and process compatibility.
Initial Review
Start with the operating point
For an initial review, working pressure and required volumetric flow rate are enough. Any further process information helps us focus the next part of the review.
Start here
Working pressure
Start here
Required volumetric flow rate
Additional process details, if available
Gas or vapor condition
Inlet temperature, liquid carryover, and solids risk
Operating cycle
Available utilities and installation conditions
If you only have an existing pump model, send that first. We can use it to frame the initial review.
Applications And Project Review
Continue from your process
Use a similar process as a reference point, then continue with the product route that best fits the actual duty.
Plastic thermoforming
See how vacuum is used through pull-down, holding, and recovery in thermoforming cycles.
View plastic thermoforming
Filtration and dewatering
Review project references and selection questions for filtration and dewatering duties.
View filtration and dewatering
Send project information
Start with working pressure and required volumetric flow rate. We will review the remaining process data with you.
Start a product reviewProduct Selection FAQ
Questions about choosing a product path
Common starting questions before an initial product review.
Need help choosing the right product path?
Send the working pressure, required volumetric flow rate, and the process details you have. We will help route the review to the relevant pump technology and product path.
